Installation
Installation services for RV, van, marine, and off‑grid
We design and install complete Victron‑based systems with correct wire sizing, fusing, and clean distribution. Systems leave documented, labeled, and tested so you can travel confidently.
What we install
Battery systems
Lithium or AGM configured with correct busbars, main disconnects, and fault protection. Monitoring via SmartShunt or BMS for accurate state of charge.
- Proper short‑circuit and overcurrent protection
- Serviceable layouts and labeled cabling
- Expansion paths when you want to grow
Inverter and charging
Multiplus or Quattro with clean AC distribution, transfer switching, and shore input protection. Charging profiles programmed for your chemistry.
- Correct neutral‑ground handling
- Surge and GFCI considerations
- Documented settings at handoff
Solar and DC‑DC
MPPT solar arrays and alternator charging that protect both your vehicle and house bank. Correct breakers, connectors, and wire gauge every time.
- Orion XS DC‑DC and alternator‑safe design
- Roof layout and penetrations that last
- Low‑loss routing and termination
Monitoring
Cerbo GX, GX Touch, and SmartShunt deliver real‑time data and make remote help possible when you need it most.
- Alerts to prevent surprises
- Remote‑ready configurations
- Clear labels and diagrams
Popular install packages
Battery Upgrade
Typical labor: 2 hr per battery
- Remove old bank and re‑terminate
- Main fuse and disconnect review
- Monitoring setup and calibration
Solar Starter
Typical labor: 3 hr first panel + 2 hr each additional
- Panel mount and roof sealing
- Charge controller install and test
- Wire drop and routing to system
Blank‑Slate Inverter
Typical labor: 6 hr base
- AC input and output distribution
- Transfer and protection check
- Programming and verification
Quality first. We quote on the higher end because our work is meticulous and built for reliability. Final labor depends on your rig and access.
How we work
1. Plan
Share your goals and photos of the electrical bay and roof. We right‑size the design and protect critical circuits.
2. Install
Clean routing, proper terminations, and labeling. We verify charge profiles and alternator safety.
3. Test
Functional tests under load, fault checks, and settings documented for future service.
4. Handover
Walkthrough plus optional remote support setup so we can assist quickly on the road.
Our build standards
- Correct fusing, wire sizing, and overcurrent protection
- Serviceable layouts with labeled conductors and devices
- Documented settings and handoff notes
- Components we trust and support
Common questions
Can you use parts I already bought
We will evaluate for safety and compatibility. If an item is not appropriate we will recommend an alternative.
How soon can you schedule
Varies by season and scope. Send your details and we will offer the earliest opening that fits your build.
Do I get diagrams and settings
Yes. We document key settings and label the system. Remote access can be configured when supported.
Can I expand later
We design with growth in mind so future solar or battery additions are straightforward.
Ready to plan your system
Tell us about your rig and goals. We will reply with next steps.