
PLUS Brushless Roof Fan with Remote Control
- Direct drop in replacement for standard 14" x 14" (355 mm) roof openings
- High efficiency brushless DC motor for minimal power draw
- Quiet operation performance rated as low as 29 dB
- 10 fan speed levels for precise climate control
- Reversible two way airflow for intake and exhaust
- Automatic temperature mode with integrated thermostat control
- Built in pleated blackout blind and insect screen
- High volume ventilation capacity of ~3000 m³/h
- Weather resistant low profile housing
- Touchscreen interface and wireless remote control included
- Integrated dual 2W LED interior lighting
- Straightforward installation with standard tools
Description:
The PLUS Brushless Roof Fan with Remote Control utilizes a high efficiency brushless DC motor to deliver a 3000 m³/h ventilation capacity. This system provides rapid cabin cooling and consistent air exchange while maintaining minimal current draw on 12V battery systems. The motor supports 10 reversible speed levels for both intake and exhaust operations to manage moisture and heat throughout the vehicle.
To ensure a quiet environment for sleeping or working, the fan operates at noise levels as low as 29 dB on lower settings. An integrated thermostat provides automatic temperature control by regulating fan speeds to maintain a consistent interior climate without manual adjustment. Users can manage all functions including the dual 2W LED lights through the responsive touchscreen interface or the included wireless remote control.
Installation follows a direct process designed for standard 14" x 14" roof openings as a drop in replacement for existing vent units. The all in one design incorporates a built in pleated blackout blind for privacy and a removable insect screen to protect the living space from debris and pests. Constructed with a weather resistant low profile housing, this fan serves as a durable and dependable ventilation base for long term mobile applications.
Installation Notes:
- We recommend testing the fan before installation to confirm that it is functioning properly.
- When testing the fan, use a power source between 9 V and 16 V DC. Exceeding 16 V will damage the control board.
- Double check the wiring before turning on the power.
Couldn't load pickup availability
Pickup currently unavailable at Bend Battery Brick and Mortar
Pairs well with
If you have any questions, you are always welcome to contact us. We'll get back to you as soon as possible, within 24 hours on weekdays.
-
Shipping Information
Use this text to answer questions in as much detail as possible for your customers.
-
Customer Support
Use this text to answer questions in as much detail as possible for your customers.
-
FAQ’s
Use this text to answer questions in as much detail as possible for your customers.
-
Contact Us
Use this text to answer questions in as much detail as possible for your customers.
FAQs
What do I do with my Lithium batteries when the weather is cold?
Cold Weather Maintenance
- You can discharge (take energy out) of the batteries down to a battery core temperature of -4 degrees F.
- You can recharge lithium batteries when the core temp of the battery is 32 degrees F or warmer (41 degrees or warmer for Victron batteries. Victron is listed in C, this is 5 Degrees C)
- If your batteries have heaters, do not leave the heaters on all night unless you are plugged into shore power, as you will use unneeded energy.
- If your batteries have heaters, but there is no way to charge (not plugged into shore power, no generator available, solar panels are covered in snow), turn your heaters off.
- If you do not have heaters, your batteries MUST be warmer then 32 degrees F to charge (41 degrees for Victron).
- Some battery heater installations do not feature a switch for remote operation. If that is the case, your heaters will turn on and off automatically as temperatures demand. Please keep an eye on your battery state of charge.
- If you are not using your trailer / RV etc. for the winter, ensure your batteries are above 80% state of charge, and disconnect the master Negative cable from the batteries. If you have Battle Born heated batteries (BB12100H) disconnect the “heat enabled” wire from the small red button terminal located right beside the positive terminal.
- Many customers have main disconnect switches that will cut the power to the batteries, but you should take extra care that they are TRULY disconnected. Often RVs will still have a C02 sensor, backlit stereo, or some other emergency sensor that is bypassing this switch. If you are in doubt, simply disconnect the main positive and negative wires that supply your batteries. After the winter storage time, you should have plenty of charge in the batteries.
- With LiFePO4 batteries, we recommend disconnecting all potential power draws from the battery and letting them sit with a full charge, or at least a 50% charge minimum. On a full charge, LiFePO4 batteries have been proven to last at least a year in proper storage conditions with a 2–3% depletion each month. If left at a half charge, the batteries have the potential to not last as long in storage.
- Tests indicate that at 0 degrees Fahrenheit, with no insulation, the Battle Born internal heater is on about 30% of the time. With no external charging or loads, it gives approximately 185 hours (7 days) of heat capability before the battery goes into a low voltage disconnect.
- If the batteries are stored without a charge, their levels could dip below what the internal Battery Management System, or BMS, can protect over the winter season. If possible, we recommend storing them fully charged in an environment above freezing. Our team recommends not leaving a completely drained battery in that state for an extended amount of time, as it can damage the cells inside. Doing so will void the warranty!
- If you do find yourself with batteries that are too cold to charge, you have a couple of options:
- Bring the batteries into a warm space or park your vehicle indoors
- Run a space heater (use caution) inside your vehicle to warm the batteries up. DO NOT use power from the batteries ie. Your inverter, to power the heater. Run an extension cord from your house to the vehicle and plug the heater into your home.
- If your batteries are above 60% state of charge, and you can confirm there is no load on the batteries (verify though your shunted meter, you should see 0.0A / 0W load), you can safely leave your batteries for 90 days without worry.
- LEAVING A LITHIUM BATTERY IN A FULLY DISCHARGED STATE WILL VOID YOUR WARRANTY!!!!
- When in doubt, remove your batteries and bring them into us to be fully charged and ready for storage. This will take 24-48 hours. TAKE PICTURES OF YOUR SYSTEM BEFORE DISCONNECTING ANY WIRING. We are not liable, nor can we assist with “I forgot where this wire goes”. That is your responsibility.
Can you install a kit/parts I already bought?
We do not install customer supplied parts or items purchased through our website. All items for your installation must be purchased through Bend Battery's retail location with guidance by a technician.
Do I need to bring my receipt with me if I have any questions?
All of our clients are saved into our computer system under their first and last name so you do not need to keep your receipt. If you for any reason have lost your receipt and would like another copy, please email us with the first and last name you used during purchase and we would be happy to email you a copy.
I am not sure how to use my VictronConnect App to monitor my system, what can I do?"
The VictronConnect App allows you to wirelessly monitor your system and recieve a wealth of information about your voltage, current, state of charge, load output, load current, solar production and much more. Below is a link to Victron Energy's Youtube channel as well as their manual on their website which gives you step by step instructions and explanations of each feature. Once you get the hang of the basic features, you will be amazed at how much information about your system is right at your fingertips. If you are still struggling, please email us at bendbattery@gmail.com for further assitance.
Are you open on the weekends?
We are open Monday-Friday 10AM-2PM for walk in customers. The rest of our day is dedicated to one-on-one appointments with clients. We reserve the weekend for our team to get out, enjoy life and recharge their own batteries so they can be ready to help you with all your questions when they return on Monday.
Do you fix cell phones, cameras and laptops?
We do not fix cell phones, cameras or laptops. Please look for a local repair shop that specializes in small electronics to assist you.
Do you sell or work on Golf Carts?
We do not sell golf carts. We exclusively sell Trojan and LifeLine batteries for drop in replacement batteries. We also make custom replacement cables made of USA made welding cable, a 16 ton 6 way hydraulic crimp press and double walled heat shrink for the ultimate connection and protection from the environment. We do not provide any other services or maintenance packages for golf carts.








